Chenille Pillow with Hidden Zipper
Making your own decorator pillows has never been this easy!
Here's what you'll need:
- Pillow form of choice
- Two pieces of fabric cut 1'' larger than pillow form. Example: If using a 14" square pillow form then cut (2) 15" squares.
- One Invisible Zipper approximately 4" shorter than side of pillow zipper will be placed on. Example: If making a 14" square finished pillow, select a 9''-10'' -length zipper.
- Chenille-It Blooming Bias or similar chenille bias product and matching thread
- One package 1/4'' -wide Dritz Wash Away Wonder Tape
- Zipper foot attachment
- Seam ripper
- Marking tool
My Chenille pillow was made using the Traveler Raindrops print from my new Signature fabrics for Art Gallery Fabrics. This print was perfect for this decorative finish because of the lines of the print could be used as a guide for chenille placement.
Chenille bias tape comes in rolls and is a loosely woven cotton cut on the bias.
Mark your fabric, if necessary to give yourself sewing guides. In my case, I could use the lines of my Traveler print and get right to sewing.
Following the manufacturer's instructions, stitch the chenille bias tape to the fabric foundation using a short stitch length. Sew down the center of the strip with a straight stitch.
Add as many rows as desired.
Assemble the pillow before blooming the chenille with water.
Hidden Zipper
On a flat surface, place the pillow front and back right sides together with edges matched. If there's a definite top and bottom to your pillow place the bottom of the pillow closest to you, as shown in illustration.
Center the zipper on the edge that will be the bottom of the pillow. Mark the fabric at the points where the zipper begins and end.
Remove zipper and stitch bottom edge using a 1/2" seam allowance from the outside edge to the marked line on each end. Backstitch to reinforce.
Using a basting stitch length, sew the space between the marks with a 1/2'' seam allowance. Do not backstitch. Press seam open.
On the wrong side, place the zipper wrong side up centered directly over the seam and between the marks. Pin in place or I like to use Dritz Wash Away Wonder Tape to hold the zipper in place without the need for pins.
If using Dritz Wash Away Wonder Tape, cut two lengths of tape as long as the zipper. Stick a length of tape to the right side of the zipper on each side, keeping the tape away from the zipper teeth. Peel off backing tape and stick the right side of the zipper to the fabric as shown above.
Reset stitch length to regular length. Switch to the zipper foot attachment for your machine and stitch zipper in place around all sides. Note: Stitch with needle in the down position and pivot around corners, sewing just past the metal ends of the zipper.
Turn to right side of the pillow and remove the basting stitches using a seam ripper. Open zipper.
Fold front and backing on the zipper seam with right sides together and edges matching. Pin. Change presser foot to regular foot. Using a 1/2'' seam allowance, stitch three sides together.
Turn right side out through zipper opening. Tip: Do not clip the corners. By leaving the corners unclipped the bulk helps to fill out the corners of the pillow. Carefully poke out corners.
Following the chenille manufacturer's instructions, wash or wet bias to bloom. Dry completely before inserting pillow form. Tip: If washing creates gaps in the chenille, simply cut a slightly longer piece of chenille bias tape longer than the gap and stitch in place using the pillow opening. Wet and fluff to blend into original chenille.
This pillow was so much fun to make and looks comfy cozy in my Signature baby room setting. Be watching for more looks from this baby room in the upcoming Signature Look Book next week.
